Table of Contents
Advertisement
6. If necessary, remove the film that covers the thermal pad at the bottom of the heat sink. Place the heat
sink on the M.2 solid-state drive. Ensure that the two mounting studs on the heat sink are in the open
position and press the studs on the heat sink into the corresponding holes in the plastic holder as
shown. Then, turn the mounting studs 90-degree clockwise to secure the heat sink to the plastic holder.
Figure 38. Installing the heat sink onto the plastic holder
Figure 39. Securing the heat sink to the plastic holder
7. Retie the cables that you have untied with the cable clip.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 108.
68
P330 User Guide
Advertisement
Table of Contents
