Table of Contents
Advertisement
c. Pull the handle of the plastic 3.5-inch storage-drive bracket to remove the storage drive from the
type-1 storage-drive cage.
Figure 95. Removing the 3.5-inch storage drive
d. Flex the sides of the bracket to remove the storage drive from the bracket.
4. To install a 3.5-inch storage drive in the type-1 storage-drive cage, do the following:
a. To install a new storage drive into the bracket, flex the bracket and align pin
4
on the bracket with the corresponding holes in the storage drive. Do not touch the circuit board
on the storage drive.
Figure 96. Installing the storage drive into the bracket
98
P330 User Guide
1
2
3
, pin
, pin
, and pin
5
Advertisement
Table of Contents
