Setting Documents - Fujitsu FI-4010CU Operator's Manual

3.2.2 Setting documents

This section explains how to set documents.
Loosening documents
Before setting documents, sufficiently loosen them by the following procedure:
Grasp no more than 25 sheets in a stack.
•
Hold the ends of stack with both hands, and bend the documents.
•
Hold the documents strongly with both hands so that both ends of the
•
documents are slanted, and then unbend the documents so that they are
inflated.
Repeat the process described above two or three times.
•
Turn the stack by 90
•
NOTE
The documents to be set should be less than 25 sheets.
Setting more than 25 documents may cause a paper jam or reading
problem.
Make sure no documents are set on the flatbed.
When scanning with the ADF, make sure that no documents are placed on the
flatbed. Any documents on the flatbed will raise the flatbed cover and cause image
quality to be degraded.
NOTE
Set the side to be scanned facing up.
o
and loosen it in the same manner as above.
13