Advertisement
The pump is excessively noisy
The coffee is dripping too
slowly (delivered from the
spout too slowly)
The coffee has an acid taste
No milk froth is formed when
making cappuccino
The water tank is empty
The tank is not correctly in place and the
valve on its base is not open
There are air bubbles in the tank
connector
The pre-ground coffee is pressed down
too firmly
There is too much pre-ground coffee
The espresso boiler outlet is blocked
The filter is blocked
The pre-ground coffee is too fine or damp Use only pre-ground coffee for espresso coffee ma-
The wrong type of pre-ground coffee is
being used
Inadequate rinsing after descaling
ECP3X30 model: The ring on the cap-
puccino maker is NOT in the cappuccino
position.
Milk not cold enough
Cappuccino maker dirty
Limescale in the water circuit
Fill the tank
Press the tank down lightly to open the valve on
the bottom
Follow the instructions given in the "Hot water"
section until water is delivered
Press the coffee down less firmly
Reduce the quantity of pre-ground coffee
Clean as indicated in the "Cleaning" section
Clean as indicated in the "Cleaning" section
kers and make sure it is not damp
Use a different type of pre-ground coffee
After descaling rinse the appliance as indicated in
the "Descaling and Rinse" section
ECP3X30 model: Place the ring in the CAPPUCCI-
NO position.
Always use 2% milk at refrigerator temperature.
Clean the holes in the cappuccino maker
thoroughly
Descale as described in the "Descaling" section
12
Advertisement
