Using The Cooker Hood; Installation Instructions - Bertazzoni KCH36XV Installation Instructions Manual

CONNECTION EXHAUST
Link a 5" 29/32 diameter air outlet chimney
to the spigot. This pipe is a separate acces-
sory.
Warning: To reduce the risk of fire use
only metal ductwork.
Attention: The appliance is provided with a
supply cord, the appliance must be positio-
ned so that the plug is accessible.
Attention : If there are three wires in the
electrical supply cable they must be con-
nected as follows:
Grey/Yellow = ground - White = neutral -
Black = line
Important : The hood manufacturer will
not be responsible for any damage or
loss caused by failure to observe these
instructions.
Important : a damaged power supply
cord must be replaced by an authorized
service provider.
WARNING
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the
event of an electrical short circuit , groun-
ding reduces the risk of electric shock by
providing an escape wire for electric current.
This appliance is equipped with a cord ha-
ving a grounding. The plug must be plugged
into an outlet that is properly installed and
grounded.
WARNING : Improper grounding can result
in a risk of electrical shock.
Consult a qualified electrician if the groun-
ding instructions are not completely under-
stood, or if doubt exists as to whether the
appliance is properly grounded.
Do not use an extension cord. If the power
supply cord is too short have a qualified
electrician install an outlet near the applian-
ce.

USING THE COOKER HOOD

The hood should be switched on before or
at the moment the cooking process initiates.
The filters are more effective if the fan is not
switched off immediately after cooking or
frying is completed, but only after a period
of some 20-30 minutes. Before using the
cooker hood please ensure that all plastic
films like on metal grease filter and stainless
steel ducting are removed.

INSTALLATION INSTRUCTIONS

This hood has been arranged to be installed
above a cook top. It can be used in 2 ways:
•EXHAUST MODE: the kitchen fumes are
purified by the metal anti-grease fumes
filters and carried outside through a ducting
system. (A-B)
INSTALLATION
The appliance must be installed at a mini-
mum height of 25'' 19/32 from an electric
cooker stove, or 29'' 17/32 from gas or
combined cooker stoves. (Fig.1)
If a connection tube composed of two parts
is used, the upper part must be placed out-
side the lower part.
Do not connect the cooker hood exhaust to
the same conductor used to circulate hot air
or for evacuating fumes from other applian-
ces generated by other than an electrical
source.
MOUNTING THE COOKER HOOD TO THE
WALL
Drill holes A-B-C according to indications
quoted in (fig.1).
Use screws and screw anchors suitable for
wall (e.g. reinforced cement, plasterboard)
for the mounting of the cooker hood. Where
screws and screw anchors are supplied
ensure that they are suitable for the type
of wall where the cooker hood is to be
mounted.
Affix the bracket Z to the wall via the drill
holes C
Hang the cooker hood on the wall using the
drill holes A.
Fasten the cooker hood using the fastening
drill holes B.
9