Advertisement
CAUTION
If you do not completely remove the moisture
when using the microfiber cloth, it can cause
electric shock and damage the main unit.
Sani punch nozzle （depending on
model）(37)
This nozzle picks up even dust inside through
beating.
The bottom part can be separated to be cleaned.
Since the bottom does not stick to the surface ,
vacuuming is easy.
When using on the bed
Lay out the blanket
When using on the floor
It's easier to clean a light blanket or sheet, by
pushing the nozzle in the direction of the arrow.
To increase cleaning efficiency for light blankets,
lay on top of a bulky blanket and then clean.
How to use(38)
Connect the nozzle to the telescopic tube.
Set the suction power control switch to MAX
POWER before vacuuming.
Depending on the type of bedding, handling
may be awkward or it may cause a lot of noise.
If this is the case, adjust the suction power
control switch to a lower setting.
Push the button 2- 3 times when the dust is
filled in the dustbin while cleaning.
When the dust is fully filled after cleaning take
the bin and turn it counterclockwise to
disconnect.
Waste the dust in the bin.
Take the bin to fix into the projection part and
then turn it clockwise to connect.
Cleaning sani punch nozzle(39)
Press the button on the rear side of the vacuum
nozzle to separate the bottom plate.
Wipe all the soiled parts of the vacuum nozzle
body with a cloth.
Wash the removed bottom plate with water and
dry it .
Straighten the punch bar on the lower section.
Insert the attachment projections on bottom
plate to the vacuum nozzle grooves.
Push down the tabs to secure.
Since the vibrator inside is composed of precision
parts, never disassemble the body. Be careful not
to let foreign objects clog the air suction part on
top of the vacuum nozzle. Since removal of the
punch bar may cause performance problems,
do not warp or remove it. Attach the bottom plate
properly before suing. Without this bottom plate,
it may not function.
For simple cleaning of the vacuum nozzle,
detach the Sani Punch nozzle from the
telescopic tube and attach the crevice tool to
vacuum dust.
WARNING
No liquid suction.
Liquid suction can cause defects.
- 13 -
Advertisement
