Replacing The Lamp; Closing The Door; Installation - Zanussi ZQA14031DV User Manual

Table of Contents

Advertisement

Problem
Door does not open easily.
If the advice does not lead to the
desired result, call the nearest
Authorized Service Centre.

REPLACING THE LAMP

The appliance is equipped with a long-
life LED interior light.
It is strongly recommended to use
original spare parts only.
Use LED bulbs (E14 base) only. The
maximum power is shown on the lamp
unit.
CAUTION! Disconnect the plug from
the mains socket.
1. Using a screwdriver, remove the screw from
the lamp cover.
2. Detach the lamp cover in the direction of the
arrows.

INSTALLATION

WARNING! Refer to Safety chapters.
Possible cause
Stored food was not wrapped.
You attempted to re-open the
door immediately after closing.
3. Replace the lamp with the one that has
identical characteristics and is specifically
designed for household appliances.
4. Reassemble the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door.
Make sure that the light switches on.

CLOSING THE DOOR

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to assembly
instructions.
3. If necessary, replace the defective door
gaskets. Contact the Authorised Service
Centre.
LOCATION
Solution
Wrap food in suitable packag-
ing before storing it in the ap-
pliance.
Wait a few seconds between
closing and re-opening of the
door.
Refer to the assembly instructions for
the installation.
9

Advertisement

Table of Contents
loading

Table of Contents