Sony HT-CT800 Operating Instructions Manual page 67

 The wireless LAN connection may be
unstable depending on the usage
environment, especially while using
the BLUETOOTH function of the
system. In this case, adjust the usage
environment.
 The wireless LAN function is not
available when using the wireless
surround function.
The wireless LAN router you want is
not shown in the wireless network
list.
 Press BACK to return to the previous
screen, and try [Wireless Setup] again
(page 20). If the wireless LAN router
you want is still not detected, select
[New connection registration] from
the network list, then select [Manual
registration] to input a network name
(SSID) manually.
Internet Connection
You cannot connect the system to
the Internet.
 Check the wired or wireless LAN
connection.
 Restart the router or wireless LAN
router.
Wireless Surround
No sound or only very low-level
sound is heard from the wireless
speaker.
 Depending on the input signal, a
surround effect with presence may
not be obtained. Depending on the
program or disc, audio signals for the
surround channels are output at a
very low level.
 When you play content compatible
with copyright protection technology
(HDCP, etc.), it may not be output
from the wireless speaker.
 Check the surround speakers
connection on [Wireless Surround
Settings] - [Surround Speaker
Connection Check].
 Adjust the volume level of the
surround speakers on [Audio
Settings] - [Speaker Settings].
The sound is delayed behind the
picture.
 When using the wireless surround
function, the sound may be delayed.
The system cannot connect to the
network.
 The wireless LAN function is not
available when using the wireless
surround function. Connect to the
network via wired LAN.
The wireless speakers cannot be
connected to the system.
 Update the software version of the
system and wireless speakers to the
latest version.
The wireless surround function
cannot be used on SongPal.
 Connect the mobile device to the
same network as that of the system
and wireless speakers.
 Use SongPal of the latest version.
Wireless Multi Room
The sound is delayed behind the
picture.
 When the sound of the [TV], [HDMI1],
[HDMI2], [HDMI3], or [Analog] input is
played in the wireless multi room
function, the sound of the system is
delayed behind the picture to
synchronize with the sound of other
speakers. If you are bothered by the
time gap between the sound and
picture, press OPTIONS and set
[Multi-room Group Sync] to [Off]. (For
the TV input, press OPTIONS and /
until "MSYNC" appears on the front
67
GB