Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for La Crosse Technology WT-2171U
Summary of Contents for La Crosse Technology WT-2171U
- Page 1 WT-2171 Radio-controlled Travel Alarm Clock...
- Page 2 Topic Page Inventory of Contents About WWVB Program Mode Initial Set-up Manual Time Setting Option Time Zone Setting Daylight Savings Time (DST) Display Mode Setting Setting the Alarm Operating the Alarm Troubleshooting Maintenance and Care Specifications Warranty Information...
- Page 3 More information on the atomic clock and WWVB can be found at www.nist.gov PROGRAM MODE Following is a list of steps to set up your new La Crosse Technology travel alarm clock. • Please begin by removing the battery Figure One cover on the rear of the travel alarm shown in figure one.
- Page 4 alarms’ ability to receive the signal. In some cases it may take several nights for the travel alarm to set. Manual Time Setting Option You can also manually set the time on your travel alarm by pressing and holding the “MODE/MIN”...
- Page 5 Daylight Saving Time Setting You can select whether or not your alarm recognizes the daylight saving time changes twice a year and automatically changes. Some areas do not change time for daylight saving time (Arizona and parts of Indiana). The default (factory) setting is daylight saving time on.
- Page 6 TROUBLESHOOTING NOTE: For problems not solved, please contact La Crosse Technology via e-mail or phone, or visit our website, www.lacrossetechnology.com Problem: The time and date will not set initially. Solution: It usually takes overnight before the clock can receive the signal due to the interference the sun has on the WWVB signal.
- Page 7 Crosse Technology immediately upon discovery of any defects covered by this warranty. Before sending the travel alarm in for repairs, please contact La Crosse Technology. The travel alarm will be repaired or replaced with the same or similar a similar model.
- Page 8 FCC ID: OMO-01RX THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: 1. THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND 2. THIS DEVICE MUST ACCEPT INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. All rights reserved.
Need help?
Do you have a question about the WT-2171U and is the answer not in the manual?
Questions and answers