Advertisement
Quick Links
1: Slide the switch to select a time zone.
2: Insert 1 fresh AA, Alkaline battery according to the polarity
marked on the case.
3: For the best reception, please place clock on a wall that faces
Ft. Collins, Colorado. During the night, your clock will
automatically set itself.
•
When the battery is installed, the hands will move to the 12:00
position and search for the radio signal.
•
If the radio signal is not received in the first 10 minutes, the
clock will start running from the 12:00 position and will
continue to run.
•
The clock is searching for the WWVB signal and once the
radio signal is decoded, the hands will automatically adjust to
the correct time. This may take up to 5 nights if there is
atmospheric interference.
Reset: If the clock does not respond to the various function
modes, press the RESET button on the movement case.
404-1210S
10" Atomic Wall Clock
Get Started
www.lacrossetechnology.com/support
Model: 404-1210S
Instruction Manual
DC: 070716
Page | 1
Advertisement
Related Manuals for La Crosse Technology 404-1210S
Summary of Contents for La Crosse Technology 404-1210S
- Page 1 Model: 404-1210S Instruction Manual DC: 070716 10” Atomic Wall Clock Get Started 1: Slide the switch to select a time zone. 2: Insert 1 fresh AA, Alkaline battery according to the polarity marked on the case. 3: For the best reception, please place clock on a wall that faces Ft.
- Page 2 (in minute increments). • Use these features to move the minute hand forward until the correct time is set. The clock will automatically leave manual mode after the SET button is not pressed for 6+ seconds. 404-1210S www.lacrossetechnology.com/support Page | 2...
- Page 3 If the clock receives the signal, the clock will set automatically to the correct time. The signal search takes approximately 3-8 minutes. • Set the clock manually, and the movement's micro-CPU will control the time keeping function. 404-1210S www.lacrossetechnology.com/support Page | 3...
- Page 4 Q. How long will the battery last? A. A good AA alkaline battery will last over 24 months. Q: Can I wire a control timing circuit to the La Crosse Technology® atomic clock? A: The clock cannot work on a timing circuit. Opening the clock voids the warranty.