La Crosse Technology 404-1225 Manual

10” atomic wall clock

10" Atomic Wall Clock

Model: 404-1225

DC: 113016

For information about WWVB, atomic time signal visit:

http://bit.ly/AtomicTime

Power up

On the back of the clock, select Time Zone and

Daylight Saving Time (DST) ON or OFF.

Insert 1 AA battery into the movement.

For best reception, place clock on a wall that faces

Ft. Collins, Colorado.

During the night, your clock will set itself.

IMPORTANT:

• Hands will move to 12:00 and search for the

atomic time signal.

• If no time signal is received, after 8-10 minutes, the

clock will start running from 12:00.

• Clock will search for the atomic time signal again

after midnight, when signal is strongest.

• Allow up to 5 nights for the clock to receive the

atomic time signal.

• On the following page are instructions to manually

set your clock.

Table of Contents

Do you have a question about the 404-1225 and is the answer not in the manual?

Page 1 • Clock will search for the atomic time signal again after midnight, when signal is strongest. • Allow up to 5 nights for the clock to receive the Model: 404-1225 atomic time signal. DC: 113016 • On the following page are instructions to manually set your clock.
Page 2 • Promptly remove expired battery. Warranty Support Once received, the atomic time signal will override manual settings. La Crosse Technology, Ltd. provides a 1-year limited time warranty (from date of purchase) on this product relating to manufacturing defects in materials & workmanship. Reset...