Refrigerator Installation; Unpacking Your Refrigerator; Installation; Installation Of Base Grille - LG LSC23924ST Owner's Manual

Excessive Weight Hazard
Use two or more people to move and install the
refrigerator.
Failure to do so can result in back or other injury.

UNPACKING YOUR REFRIGERATOR

Remove tape and any temporary labels from your
refrigerator before using. Do not remove any stickers that
feature warnings, the model serial number.
To remove any remaining tape or glue, rub the area briskly
with your thumb. Tape or glue residue can also be
removed by rubbing a small amount of liquid dish soap
over the adhesive with your fingers. Wipe with warm water
and dry.
Do not use sharp instruments, rubbing alcohol, flammable
fluids or abrasive cleaners to remove tape or glue. These
products can damage the surface of your refrigerator. For
more information, see the Important Safety Instructions
section.
Refrigerator shelves are installed in the shipping position.
Please reinstall shelves according to your individual storage
needs.
When Moving Your Refrigerator
Your refrigerator is heavy. When moving the
refrigerator for cleaning or service, be sure to protect
the floor. Always pull the refrigerator straight out when
moving it. Do not wiggle or walk the refrigerator when
trying to move it, as floor damage could occur.
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from refrigerator.
Failure to do so can result in death, explosion or fire.

REFRIGERATOR INSTALLATION

easily
7

INSTALLATION

1. Avoid placing unit near heat sources, direct sunlight or
moisture.
2. To minimize noise and vibration, the refrigerator
MUST be installed on a solidly constructed floor.
3. Carpeting and soft tile surfaces are not recommended.
4. NEVER install the refrigerator on a platform or a
weakly supported structure.
5. Install this appliance in an area where the
temperature is between 41 °F (5 °C) and 110 °F
(43 °C). If the temperature around the appliance is too
low or high, cooling ability may be adversely affected.
Keep a Proper Distance from Adjacent Objects
Please keep the refrigerator at an adequate distance from
other objects. Insufficient spacing can reduce the
refrigerator's freezing efficiency and increase electricity
consumption.
• Be careful when you work with the hinge, base grille,
stopper, etc. You may be injured.
• Do not put hands or metal sticks into air vents, base
grille or bottom of the refrigerator. You may be injured
or receive an electrical shock.

INSTALLATION OF BASE GRILLE

To install or replace base grille:
1. Place base grille into position and insert and tighten
screws.
To remove the base grille:
1. Open the doors. (Refrigerator and Freezer)
2. Once doors are open, remove screws from base
grille. Remove base grille and set safely aside.
2" (5.08 cm)