Table of Contents
Advertisement
Operating the appliance
en
Intensive setting
You can use the intensive setting if there is a large
build-up of odours and fumes/vapours.
Switching on
Touch the
symbol until
@
panel.
After approx. 6 minutes, the extractor hood
Note:
automatically switches back to fan setting 3.
Switching off
If you want to end intensive mode before the preset
time expires, touch the
setting you require.
Boost function
Switching on
Touch the
symbol.
&
After approximately 20 seconds, the extractor
Note:
hood automatically switches back to the fan setting that
was set beforehand.
Switching off
If you want to end the Boost function before the preset
time expires, touch the
powerBoost position
On some appliances, the glass front can be adjusted to
an intermediate position (powerBoost position). The
powerBoost position can be used for eliminating
particularly strong cooking smells and large amounts of
steam.
Take hold of the glass front in the centre and open it
carefully.
Fan run-on time
Switching on
Touch the
A
symbol until
panel.
The fan will run at fan setting 1.
After approximately 10 minutes, the fan will switch itself
off automatically.
Switching off
Touch the
symbol.
@
This immediately stops fan run-on.
Saturation display
If the metal grease filters or activated charcoal filter are/
is saturated, the corresponding symbols will flash once
the appliance has been switched off:
Metal grease filter:
■
Activated charcoal filter:
■
Metal grease filter and activated charcoal filter:
■
and
"
8
is shown on the display
2
symbol to select the fan
A
&
symbol.
x
lights up on the display
!
"
If you have not yet done so, the metal grease filters
should now be cleaned or the activated charcoal filter
replaced. ~ "Cleaning and maintenance" on page 9
The saturation indicators can be reset while they are
flashing. To do this, touch the
Switching over the display for air recirculation mode
For air recirculation mode, the electronic controller must
be switched over accordingly:
The extractor hood must be connected and switched
■
off.
Touch and hold the
■
time until "2" lights up for air recirculation mode
(filters that cannot be regenerated).
Repeatedly touching and holding this button
■
combination makes "3" light up for air recirculation
mode (filters that can be regenerated).
Repeatedly pressing and holding this button
■
combination switches the electronic controller back
over to air extraction mode ("1" ).
emotionLight Pro
The emotionLight Pro can be switched on and off
independently of the fan.
Touch the
i
Setting the brightness
Press and hold the
brightness is reached.
Setting the colour
Switch off the fan.
1.
Touch the
2.
Touch the
3.
is selected.
Audible signal
Switching on
Touch and hold the
for approximately 3 seconds when the fan is switched
off. An audible signal will sound as an
acknowledgement.
When the signal tone is activated,
Switching off
Touch and hold the
for approximately 3 seconds when the fan is switched
off. An audible signal will sound as an
acknowledgement.
When the signal tone is deactivated,
!
symbol.
A
and
symbols at the same
#
@
symbol.
symbol until the required
i
symbol.
i
or
symbol until the colour you require
A
@
and
symbols at the same time
#
&
‚
and
symbols at the same time
#
&
will be lit.
will be lit.
‹
Advertisement
Table of Contents
