Table of Contents
Advertisement
Preparation
Optional accessories
Insulated assembly pipe,
Ø 6.35 mm (1)
Insulated assembly pipe,
Ø 12.70 mm (1)
18
Drain Hose, 2 m long (1)
Pipe clamp A (3)
Vinyl tape (2)
Putty 100 g (1)
M4 x 25 tapped screw (6)
Accessories in the outdoor unit package
3-wire
Assembly Cable(1)
09/12/18
Rubber Leg(4)
32 English
RAC MEDIA ODM 아프리카향 IBIM_EN_DB68-00000A-00.indb 32
Insulated assembly pipe,
Ø 9.52 mm (1)
09/12
Insulated assembly pipe,
Ø 15.88 mm (1)
24
Foam Insulation(1)
Pipe clamp B (3)
PE T3 foam tube insulation (1)
Drain plug (1)
Cement nail (6)
4-wire
Assembly Cable(1)
24
NOTE
• A flare nut is attached to the end of each pipe of an
evaporator or a service port. Use flare nuts when
connecting the pipes.
• Wire assembly cables are optional. If they are not
supplied, use standard cables.
• The drain plug and the rubber legs are included only
when the air conditioner is supplied without assembly
pipes.
• If these accessories are supplied, they are in the
accessory package or outdoor unit package.
Tools
General tools
• Vacuum pump
• Pipe bender
(Backward flowing
• Spirit level
prevention)
• Screwdriver
• Manifold gauge
• Spanner
• Stud finder
• Drill
• Torque wrench
• L-wrench
• Pipe cutter
• Measuring tape
• Reamer
Tools for test operation
• Thermometer
• Resistance meter
• Electroscope
Step 1.3 Drilling a hole through the
wall
Before fixing the installation plate to a wall and then fixing
the indoor unit to the installation plate, a window frame,
or a gypsum board, you must determine the position of a
hole (with 65 mm inner diameter) through which the pipe
bundle (consisting of power and communication cables,
refrigerant pipes, and drain hose) will pass and then drill
that hole.
1
Determine the position of a 65 mm hole in
consideration of the possible directions of the pipe
bundle and the minimum distances between the hole
and the installation plate.
2017-01-20 오전 11:28:38
Advertisement
Table of Contents
