Built-In Auto Light (Using The Light, Rplacing The Bulb) - Panasonic Palmcorder Multicam PV-L672 Operating Instructions Manual

Built-in Auto Light
Using the Light
For recording in dim lighting.
3
1
CAUTION:
Light becomes hot.
Never cover Light while on.
Note:
• Using Light reduces battery operating time.
• Provide proper ventilation when using
Light extensively in a hot environment.
• Using Light when the Camcorder is
powered by a car battery may shorten
bulb life.
• Set Light to OFF when not in use.
Replacing the Bulb
B
A
2
3
DANGER:
Use only replacement bulb (PART NO. VLLW0015) supplied by Panasonic to reduce risk
of fire.
Handle new bulb with cloth or tissue as skin oils will decrease bulb life.
Remove lens cover and allow bulb to cool before replacing to avoid possible burn hazard.
16
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com
2
,
1
Before you begin...
• Connect Camcorder to power source.
• Set POWER to CAMERA.
1
Press MENU for
MENU mode. Press
UP or DOWN to
select LIGHT MODE
2
Press DISPLAY to set OFF/ON or
OFF/ON/AUTO. Press MENU to exit.
3
Press LIGHT repeatedly for Light ON,
OFF, or AUTO.
• In AUTO, light turns itself on/off
according to lighting conditions.
EVF or LCD Monitor
A
A
A
Before you begin...
• Order Part No. VLLW0015 for replacement
bulb.
• Set POWER to OFF.
1
Slightly raise portion
to unhook, and slide portion
forward to remove.
2
Using Tweezers or needle-nose pliers,
carefully remove bulb.
Take unit to service center if you need
•
assistance.
3
Replace bulb using a clean cloth or
tissue. (Do not touch with fingers.)
4
Replace lens cover.
Note:
• Handle bulb gently. Excessive force may
cause bulb to crack.
.
: Light is on.
: Light mode is auto.
A of lens cover
B