Reassemble Pump - AeroGarden PRO Cleaning Manual

Reassemble Pump

5
With Grow Surface upside down, insert the Pump back into the
A
Pump Tower making sure that:
• The Rubber Feet of the Pump are facing up.
• The Face Plate is facing toward you.
• Pump is securely seated in the tube in the Pump Tower.
• The Pump Wire goes behind and underneath the Pump, and
lines up with Wire Slot.
Page 6
Insert Cover Plate in the
B
bottom of the Pump Tower
and push down until all
corners snap in place.
Push Pump Wire back in
C
Wire Slot.
Turn Grow Surface right side up and place clean or new Filter back
D
in slots in front of the Pump. (If you do not have a Filter, please see
Troubleshooting on page 6.)
If you are working with a planted AeroGarden, skip
step E (below) and proceed to final steps on page 7.
Replace Grow Surface in Bowl* .
E
Congratulations
Your AeroGarden is ready for its next planting!
* If you cleaned your Pump to reduce noise, fill the Bowl with water and plug in
your AeroGarden. If the Pump is still noisy, please contact Customer Service.
!