Page of 16

AeroGarden 100610-BLK Quick Start Manual

Aerogrow international, inc. indoor greenhouse kit quick start guide.
Hide thumbs
Quick Start
Simple Steps
To Get Your
Up and Growing
Model #s: 100610-BLK; 100610-WHT; 100610-SLR
Input Voltage: 120V, 60Hz, 1.5A
Date Code:


   Related Manuals for AeroGarden AeroGarden 100610-BLK

   Summary of Contents for AeroGarden AeroGarden 100610-BLK

  • Page 1

    Quick Start Guide Simple Steps To Get Your Up and Growing Model #s: 100610-BLK; 100610-WHT; 100610-SLR Input Voltage: 120V, 60Hz, 1.5A Date Code:...

  • Page 2

    5. Use AeroGarden only for its intended use as described in instructions. Do not use attachments not recommended by manufacturer. 6. Never operate AeroGarden if it has a damaged cord or plug, if it is not working properly, if it has been dropped and damaged, or if it has been dropped in water.

  • Page 3

    Quick Start Assembly Unpack Your AeroGarden Lamp Hood (front view) Bowl (front view) Base (front view) Deluxe B Grow Bulbs (2) Insert Grow Bulbs into Lamp Hood Lamp Hood (bottom view) Push straight in. DO NOT TWIST BULBS! remember to replace Grow Bulbs every 6 months.

  • Page 4

    Lamp Arm Center hands over Lamp Arm and push Lamp Hood down until you hear a “click.” Moving Your AeroGarden Use one hand to grasp Lamp Arm Gently slide AeroGarden toward the surface edge and place other hand under...

  • Page 5

    Place Your Garden Under: A space that allows 22” (56cm) clearance for the full height of raised lamp On: A sturdy, water- tolerant surface (Metal surfaces may cause noise due to vibration) Near: A standard electrical outlet, per local regulations Away From Reach of children and pets Direct sources of heat (e.g., stove, furnace vents)

  • Page 6

    Planting Your Garden Add Water Using a Spouted Container Fill to “Fill To Here” (located inside Bowl) When additional water is needed, “Water Low” light on Control Panel will blink. Add water to raise level up to “Fill To Here” inside Bowl. It is okay to add water up to “Fill To Here”...

  • Page 7: Plant Your Garden

    • Consider plant height when combining Seed Pods from two 3-pod Seed Kits. Refer to “Plan Your Garden Layout” on page 5 when deciding where to place Seed Pods in your 6-pod AeroGarden. • When planting – use BOTH Starting Nutrients (two tablets) from each 3-pod Seed Kit.

  • Page 8

    Planting Your Garden Place Bio-Domes Place a Bio-Dome on each Seed Pod. Press Bio-Dome down until its rim almost touches Grow Surface. Add Starting Nutrient Tablets and Record Planting Date Record Planting Date Record the date your Seed/Plant Kit was planted on front cover of the Tending &...

  • Page 9

    Starting Your Garden Plug Cord into Electrical Outlet What will happen... A green light on Control Panel will illuminate. Grow Bulbs will come on. Look under Lamp Hood to check that both bulbs are lit. If not , check to see if: •...

  • Page 10

    • Your lights will stay on for about 16 hours and will shut off for about 8 hours. • Your lights will come on every day at the time you plugged in your AeroGarden 6. button until you reach the type of plant you are growing (Vegetables, Salad Greens, etc.).

  • Page 11

    Personalize Your Light Timer Your AeroGarden 6 has lights and a built-in timer that automatically provide plants with the optimal amount of “sunlight” (about 16 hours) and “night” (about 8 hours), depending on plant type you selected. As long as plants get this amount of light, it does not matter when lights are turned off. * Many people find it conve- nient to have lights go on in the morning and off at night to match their own wake and sleep schedule.

  • Page 12

    After replacing Grow Bulbs, press “Reset” button to restart grow bulb timer and turn off flashing light. noTe: If you store your AeroGarden 6 between uses, grow bulb timer automatically stops when Garden is unplugged. † See complete replacement instructions on next page.

  • Page 13

    IMPorTAnT: To avoid burning, be sure Grow Bulbs are cool before handling. • Insert new Grow Bulbs into Lamp Hood. Vegetables Live Plants • Plug in AeroGarden 6 and press and release “Reset” button to restart grow bulb timer. (continued) Replace Bowl on Base and plug in AeroGarden 6.

  • Page 14

    Prepare For Your Next Garden cleaning Instructions for your AeroGarden Use only water and mild soap when cleaning your AeroGarden (except when Sanitizing - Step 6). Do not use abrasive cleaners or run through the dishwasher. When your garden has completed its growing cycle…...

  • Page 15

    Prepare For Your Next Garden Replanting Your AeroGarden If you have already grown a garden in your AeroGarden 6, please follow the instructions below to reset the nutrient timer: • Press and hold “Reset” button until red “Add Nutrients” light blinks 3 or 4 times (about 9 seconds).

  • Page 16

    U.S. CAUTION You are cautioned that any changes or modifications not expressly approved in this manual could void your – authority to operate this equipment. noTe: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are de- signed to provide reasonable protection against harmful interference in a residential installation.

Comments to this Manuals

Symbols: 0
Latest comments:
  • Machettev Jul 13, 2017 09:53:
    No book in the box to tell you how it works