Summary of Contents for AeroGarden AeroGarden 100710-BSS
Page 1
Up and Growing Congratulations on your purchase of the aerogarden Pro With this beautiful, brushed stainless-steel AeroGarden you get all the features of the original AeroGarden, enhanced with… • Adaptive Intelligence – which automatically adjusts the amount of light and water plants receive at every stage of your plant’s life •...
16. Use only approved and supplied parts and accessories. Use only lamp model 100629 (N. America) or 200629 (Europe & Aus- tralia) Grow Bulbs with this AeroGarden model. Use of any other kind of accessory is not recommended. Replacement parts can be ordered from www.aerogardensupport.com or from your retailer.
Quick Start Assembly Unpack Your AeroGarden Lamp Hood (front view) Bowl (front view) Base (front view) Grow Bulbs (2) Insert Grow Bulbs into Lamp Hood Lamp Hood (bottom view) Push straight in. DO NOT TWIST BULBS! remember to replace Grow Bulbs every 6 months.
Page 4
“click.” Moving Your AeroGarden PRO Use one hand to grasp Lamp Arm Gently slide AeroGarden toward the surface edge and place other hand under Base (back view) need additional HelP? For supplies and information, visit… www.aerogardensupport.com...
Page 5
Place Your Garden Under: A space that allows 22” (56cm) clearance for the full height of raised lamp On: A sturdy, water- tolerant surface (Metal surfaces may cause noise due to vibration) Near: A standard electrical outlet, per local regulations Away From Reach of children and pets Direct sources of heat (e.g., stove, furnace vents)
Planting Your Garden Add Water Using a Spouted Container Fill to “Fill to Here” (located inside Bowl) When additional water is needed, “Water Level Low” light on Control Panel will blink. Add water to raise level up to “Fill To Here” inside Bowl. It is okay to add water up to “Fill To Here”...
Page 7
Place Bio-Domes ™ Place a Bio-Dome on each Seed Pod. Press Bio-Dome down until its rim almost touches Grow Surface. Add Starting Nutrient Tablets and Record Planting Date Record Planting Date Record the date your Seed Kit was planted on front cover of the Tending &...
Page 8
Starting Your Garden Plug Cord into Electrical Outlet What will happen... A green light next to “Germination” and a white light on Control Panel will illuminate. Grow Bulbs will come on. Look under Lamp Hood to check that both bulbs are lit. If not , check to see if: •...
Page 9
16 hours and will shut off for about 8 hours.* • Your lights will come on every day at the time you plugged in your AeroGarden PRO *except when using “24-Hour light” setting, which sets lights to be on for 24 hours.
Page 10
Flower & Vegetable plants. they require a daily dark period in order to produce flowers. if your plants will receive any room light during the day (natural or artificial), we recommend setting your aerogarden lights to be on during the day.
Page 11
• When blinking stops (about 5 seconds), the light next to Strawberries will remain on and the green light next to “Germination” will light up. Your AeroGarden PRO is now on the “24-Hour Light” setting. (The lights and pump will remain on 24 hours a day.) •...
Page 12
After replacing Grow Bulbs, press “Reset” button to restart grow bulb timer and turn off flashing light. note: if you store your aerogarden between uses, grow bulb timer automatically stops when is unplugged. *see complete replacement instructions on next page.
Page 13
Raise lamp Hood (lights) As plants grow to 1-2” from lights, raise Lamp Arm one Locking Button at a time. Be sure Lamp Arm is set on the lowest Locking Button when starting your AeroGarden PRO Unplug AeroGarden PRO and remove Bowl from Base.
Page 14
Prepare For Your Next Garden Cleaning instructions for your aerogarden Use only water and mild soap when cleaning your AeroGarden (except when Sanitizing - Step 7). Do not use abrasive cleaners or run through the dishwasher. When your garden has completed it’s growing cycle…...
Page 15
Prepare For Your Next Garden Replanting Your AeroGarden If you have already grown a garden in your AeroGarden PRO below to reset the nutrient timer: • Press and hold “Reset” button until red “Add Nutrient” light blinks 3 or 4 times (about 9 seconds).
Page 16
U.S. CAUTION You are cautioned that any changes or modifications not expressly approved in this manual could void your – authority to operate this equipment. note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are de- signed to provide reasonable protection against harmful interference in a residential installation.
Need help?
Do you have a question about the AeroGarden 100710-BSS and is the answer not in the manual?
Questions and answers