Panasonic KY-T937SL Operating & Installation Instructions Manual page 20

Troubleshooting
Heat Power
Symptom Possible cause
The heating power is Overheating Prevention Function
weaker. If the base of the cookware overheats, the heating
power will automatically reduce. The power indication
will remain the same. The power returns to normal after
the cookware cools down.
Unsuitable cookware, e.g. ceramic and earthenware
pans, are used.
Do not use ceramic and earthenware pans even
if they are for induction heating as they are not
effi cient. (See page 15)
When multiple cooking The power level is automatically regulated so that
zones are used together, overall power consumption does not exceed the limit.
■ The heating power (See page 13)
decreases. The power indicator for a cooking zone may decrease
on its own.
■ The power indicator
automatically Even after touching the
decreases. power level , it may not increase the power level and the
appliance will beep.
■ The power level can
not be increased.
36
EN-
0 : 02
5
slider to adjust
Troubleshooting
Autoboil Mode
Symptom Possible cause
Heating time takes too ■ The base of the pan or top plate is dirty.
long.
■ A lid has not been used.
■ Water was added to the pan during Autoboil Mode.
■ The lid is removed or the pan is moved during Autoboil
Mode.
■ Water has not boiled The cookware size and material (e.g. non-stick coating)
after beeping. and the volume of water may affect the sensor detection.
Select a temperature as required.
■ Water has boiled but
does not beep.
No power - heating The top plate is too hot for Autoboil Mode. Autoboil Mode
does not start. will start automatically when the top plate has cooled
down.
Low Temperature Cooking Mode
Symptom Possible cause
■ Preheating time ■ The pan is not in the correct position. (See page 14)
takes too long.
■ The base of the pan or top plate is dirty.
■ The actual
■ Water, oil, or food was added during preheating.
temperature is
■ The temperature on the base of the pan may vary
different from the set
from the set temperature depending on the type of
temperature.
cookware.
■ Food is not achieving
■ Due to the variety of food types and pans, the actual
set temperature.
temperature of food may be different from the set
temperature.
■ Cookware with a non-stick coating may affect the
sensor detection.
Adjust the temperature as required with
No power - heating The top plate is too hot for the temperature set. Heating
does not start. will start automatically when the top plate has cooled
down.
slider.
37
EN-