Table of Contents
Advertisement
2. Setting up the Display
B
A
(main)
Top-Left
B
A
(main)
• Swap: The main picture source and
the sub picture source swapped on
the display.
Swap A and B source in [PIP] mode:
B
A
(main)
• Off: Stop MultiView function.
Note
1. When you do the SWAP function,
the video and its audio source will
swap at the same time. (Refer to page
<7> "Independent audio playback,
regardless of video input" for more
detail.)
2. When enable Multiview by interlace
timing ( i-timing), the sub-windows
display may flicker.
Please change sub-window signal
source to be progressive timing(
P-timing).
A
(main)
B
Bottom-Left
A
(main)
B
B
↔
(main)
2.4 Remove the Base Assembly
for VESA Mounting
Before you start disassembling the
Display base, please follow the
instructions below to avoid any possible
damage or injury.
1. Place the Display face down on a
smooth surface. Pay attention not
to scratch or damage the screen.
A
2. Loosen the assembly screws, then
detach the bases from the Display.
12
Advertisement
Table of Contents
