Printing Does Not Start - Canon PIXMA TS302 Online Manual

Printing Does Not Start

Make sure printer is turned on.
Check1
If not, make sure the printer is securely plugged in and press ON/Stop button to turn on.
The ON lamp flashes while the printer is initializing. Wait until the ON lamp stops flashing and remains lit.
Note
• If you are printing large data such as photos or other graphics, printing may take longer to start. The ON
lamp flashes while the computer is processing data and sending it to the printer. Wait until printing starts.
Make sure printer is properly connected to computer.
Check2
When the printer is connected to your computer with a USB cable, check the following:
• If you are using a relay device such as a USB hub, disconnect it, connect the printer directly to the
computer, and retry the printing. If printing starts normally, there is a problem with the relay device. Contact
the vendor of the relay device.
• There could also be a problem with the USB cable. Replace the USB cable and retry the printing.
If you use the printer over a LAN, make sure the printer is correctly set up for network use.
Cannot Find Printer while Using Wireless LAN
Note
• IJ Network Device Setup Utility allows you to diagnose and repair the network status. Download it from the
web page.
For Windows
For macOS
Make sure paper settings match information set for rear tray.
Check3
If the Alarm lamp and Paper lamp flash at the same time, the paper settings and paper size do not match the
information set for the rear tray.
Press the ON/Stop button to stop printing and check the settings.
An Error Occurs
If printing from a computer, delete jobs stuck in print queue.
Check4
• For Windows:
Deleting the Undesired Print Job
• For macOS:
Deleting the Undesired Print Job
272