Gigabyte R181-340 Service Manual page 95

RAID Mode: When set to RAID, the SATA controller enables both its RAID and AHCI functions. You will
be allows access the RAID setup utility at boot time.
Options available: AHCI/RAID. Default setting is AHCI.
Alternate Device ID on RAID
Enable/Disable Alternate Device ID on RAID mode.
Options available: Enable/Disable. Default setting is Disabled
Please note that this option appears when HDD is in RAID Mode.
SATA Port 0/1/2/3/4/5/6/7
The category identifies SATA hard drives that are installed in the computer.
System will automatically detect HDD type.
Port 0/1/2/3/4/5/6/7
Enable/Disable Port 0/1/2/3/4/5/6/7 device.
Options available: Enable/Disable. Default setting is Enable.
Hot Plug (for Port 0/1/2/3/4/5/6/7)
Enable/Disable HDD Hot-Plug function.
Options available: Enable/Disable. Default setting is Disable.
Spin Up Device (for Port 0/1/2/3/4/5/6/7)
On an edge detect from 0 to 1, the PCH starts a COM reset initialization to the device.
Options available: Enable/Disable. Default setting is Disable.
(Note 1) Only appears when HDD sets to RAID Mode.
(Note 2) Only Supported when HDD is in AHCI or RAID Mode.
(Note 1)
(Note2)
(Note2)
- 95 - BIOS Setup