Table of Contents
Advertisement
46
ANTENNA ISOLATOR INSTALLATION GUIDE
ANTENNA ISOLATOR INSTALLATION GUIDE
* Depending on the country
Use this to install TV in a place where there is a voltage difference between GND of power and GND of
antenna signal. If there is a voltage difference between GND of power and GND of antenna signal, the
antenna contact might be heated and excessive heat might cause an accident.
You can improve the safety when watching TV by efficiently removing power voltage from TV antenna. Avoid
disconnecting the antenna Isolator after installation.
Unpacking and Exterior of antenna isolator
Plug 1
Isolator (Type A)
Connection method
1
Connect Plug 1 with a signal cable.
2
Connect Plug 2 with ANT input end on the back of TV.
Image shown may differ from your TV.
y
y
Cable / Antenna
Cable / Antenna
"Equipment connected to the protective earthing of the building installation through the mains connection
or through other equipment with a connection to protective earthing - and to a cable distribution system
using coaxial cable, may in some circumstances create a fire hazard. Connection to a cable distribution
system has therefore to be provided through a device providing electrical isolation below a certain
frequency range (galvanic isolator, see EN 60728-11)"
When applying the RF Isolator, a slight loss of signal sensitivity can occur.
Plug 2
or
Isolator
or
Isolator
Plug 1
Plug 2
Isolator (Type B)
TV
Set Top Box
TV
Advertisement
Table of Contents
