Electrical Connection - Beko WIY84540F User Manual

Adjusting the feet with water level
• You must remove the Detergent Drawer to set the Water Level.
• For the system to operate properly, the bubble inside the Water Level must be in the
middle.
• If the bubble inside the Water Level is on the left, the pre-set right foot of the Washing
Machine must be adjusted.
• If the bubble inside the Water Level is on the right, the pre-set left foot of the Washing
Machine must be adjusted.
• If the bubble inside the Water Level is at the back, the pre-set front feet of the
Washing Machine must be turned to the left (clockwise).
• If the bubble inside the Water Level is at the front, the pre-set front feet of the
Washing Machine must be turned to the right (anti-clockwise).

4.4.7 Electrical connection

Connect the product to a grounded outlet protected by a 13 A fuse. Our company shall not
be liable for any damages that will arise when the product is used without grounding in
accordance with the local regulations.
• Connection must comply with national regulations.
• The wiring for the electrical outlet circuit must be sufficient to meet the appliance
requirements. Use of a Groud Fault Circuit Interrupter (GFCI) is recommended.
• Power cable plug must be within easy reach after installation.
• If the current value of the fuse or breaker in the house is less than 13 Amps, have a
qualified electrician install a 13 Amp fuse.
• The voltage specified in the "Technical specifications" section must be equal to your
mains voltage.
• Do not make connections via extension cables or multi-plugs.
B
WARNING:
16 / EN
Damaged power cables must be replaced by the Authorised Service Agents.
Washing Machine / User's Manual