Table of Contents
Advertisement
Hook Up Antenna and VCR to the TV
Connect an off-air antenna and VCR to the TV
1
Locate the Antenna/Cable In jack on the back
of the VCR.
2
Connect the wire that runs from the antenna,
according to one of the diagrams to the right. As
required, make the other connections as shown to
the right.
3
Remove the back of the remote, put in
two AA batteries.
4
Plug in the TV. The TV is designed to operate on
standard current, 120-volt 60 Hertz AC. Do not
attempt to operate it on DC power.
120 V AC
60 Hz
5
Go to page 12 to Auto Program the TV.
No A/V cables are included with the Zenith TV.
Without A/V cables, most VCRs will not play
videocassettes in stereo sound.
P A G E 8
Back of
Remote
Antenna
Flat Wire
(300 ohm)
TV Back
Matrix
Antenna
Out
Cable
Video
R- Audio - L
In
In
M.P.I.
S-Video
R- Audio - L
In
In
Antenna
RF Coaxial Wire
(75ohm)
TV Back
Matrix
Antenna
Out
Cable
Video
R- Audio - L
In
In
M.P.I.
S-Video
R- Audio - L
In
In
VCR Back
VCR Back AV Panel
output
In
switch
3 4
Out
Video
Audio
300/75 ohm
Adapter
A/V cables
not included
with TV
VCR Back
VCR Back AV Panel
output
In
switch
3 4
Out
Audio
Video
A/V cables
not included
with TV
Advertisement
Table of Contents
