Troubleshooting - Philips Lumea SC1993/00 Manual

English
16
Protection against electric shock
Protections rating
Operating conditions
Spectrum of body attachment

Troubleshooting

Problem
The device/adapter
becomes warm during use
The 'ready to flash light'
doesn't light up when I
place the attachment on
my skin, but the cooling fan
works.
The 'ready to flash light'
lights up green but the
device does not produce a
flash when I press the flash
button.
I cannot increase or
decrease the light intensity
settings/All intensity lights
are blinking alternately
The device produces a
strange smell.
This chapter summarizes the most common problems you could encounter
with the device. If you are unable to solve the problem with the information
below, visit www.philips.com/support for a list of frequently asked questions
or contact the Consumer Care Center in your country.
Possible cause
This is normal.
The overheat protection has
been activated.
The device needs to be reset. To reset the device, switch it off and
The device needs to be reset. To reset the device, switch it off and
The attachment or the filter
glass is dirty.
You have not removed the
hairs on the area to be
treated properly. These hairs
may get burned and can
cause the smell.
Class II
IP 30 (EN 60529)
Temperature:+15 ºC to 35 °C
Relative humidity: 30% to 95%
>530nm
Solution
No action required.
When the overheat protection has been
activated, the fan still works. Do not
switch off the device, but let it cool down
for approx. 15 minutes before you
continue to use it.
switch it on again.
switch it on again.
Clean the attachment carefully.
Pretreat your skin before you use Lumea.