Set Up On A Pedestal With Drawer; Installation Checklist; Importance Of Installing On A Solid, Level Floor - Bosch 500 Series Use And Care Manual / Installation Instructions

Hide thumbs Also See for 500 Series:
Table of Contents

Advertisement

Washer drum contents
Two AquaShield ® water supply hoses are shipped in
the washer drum. Be sure to remove each of these items
from the drum before using the washer.
Hot water AquaShield ® hose
H
Cold water AquaShield ® hose
P
NOTICE: If any parts are missing please notify your
dealer immediately.

Set up on a pedestal with drawer

Pedestal item number: WMZ 20490
Mount washer on the pedestal according to the
instructions in the installation kit.
12

Installation checklist

Review the following list and check off each step as it is
completed during installation.
Installation Step
è
If installing to a pedestal
(base), complete the base
installation before remov-
ing the transportation bolts
Completely remove all four
shipping bolts keeping the
bolt and bushing assem-
blies intact
Connect the water supply
hose and drain hose
Connect the electrical
power
Slide the washing machine
into its final location
Level the washing machine
(as low as possible)
Before washing laundry, run
the Drum Clean program
Importance of installing on a solid, level
floor
Your new Bosch washing machine utilizes high spin
speeds to achieve superior water removal from your
laundry resulting in reduced drying time. It is important to
install your washing machine on a floor that will provide
firm support. This prevents the washer from experiencing
excess vibration during spinning that could cause the
washer to move or be noisy.
The installation surface must be solid and level in both
directions. Avoid installing your washer on soft surfaces
such as floors with carpet or foam backed covering
material.
If installing the washer on a wooden floor, observe the
following:
install the washer in a corner for better support if
possible.
if necessary, reinforce the floor by screwing a water
resistant wooden board to the floor (minimum of
1.18 in./30 mm thick).
Page
~ Remove the trans-
port bolts; Page 13
~ Remove the trans-
port bolts; Page 13
~ Water
connections; Page 13
~ Electrical
connection; Page 17
~ Leveling the
washer; Page 16
~ Before loading
your first load of
laundry; Page 20

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wat28401uc

Table of Contents