Installation Instructions; Introduction - Bosch 500 Series Use And Care Manual / Installation Instructions

Hide thumbs Also See for 500 Series:
Table of Contents

Advertisement

Under counter (Less Desirable)

Installation instructions

WARNING
9
RISK OF FIRE, ELECTIRICAL SHOCK OR INJURY
TO PERSONS
To reduce the risk of fire, electric shock or injury to
persons, read the Important Safety Instructions at
the front of this manual before installing or operating
this appliance.
CAUTION
9
WASHING MACHINE IS HEAVY
Use additional help and care when lifting and
positioning.

Introduction

Read these installation instructions completely and
carefully before starting to install your new washing
machine. The information contained can save you time
and effort and will help to ensure optimum performance
of your new washer. Be sure to observe all warnings and
cautions.
10
If front of the appliance is covered ventilation openings
must be installed.
E & F are minimum area sizes
E
63 sq.in.
F
63 sq.in.
G & H actual spacing dimensions for min. open area
sizes
G
3 in.
H
14 in.
NOTICES
Frozen hoses can tear or burst. Do not install the
washing machine outdoors or in an area exposed to
freezing condtions.
If the washing machine is located in a room which will
be exposed to temperatures below freezing, or if it is
located in a cabin that is being shut down for the
winter, any residual water in the pump or water inlet
hose(s) must be drained.
Take care not to damage the washing machine. Do
not hold on to protruding parts (e.g. door) when lifting.
Do not push against the appliance door glass due to
risk of damage.
In addition to the safety information listed here, the
local water and electric authorities may have special
requirements that must be followed.
If in doubt, have the appliance installed by an
authorized technican.
Hidden surfaces may have sharp edges. During
service use caution when reaching inside the washer
housing.
These installation instructions are intended for use by
qualified installers. In addition to these instructions, the
installation must comply with:
- for the United States - National Electrical Code, ANSI/
NFPA70 - and latest editions of the State and municipal
and/or local regulations.
- for Canada - Canadian Electrical Code C22.1 - and the
latest editions of the Provincial, Municipal and/or local
regulations.
404 sq.cm
404 sq.cm
7.6 cm
35.6 cm

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wat28401uc

Table of Contents