HART HPMT01 Operator's Manual page 5

FEATURES
PRODUCT SPECIFICATIONS
Oscillations per minute (OPM) ............................................................................................................................. 0-20,000/min
ASSEMBLY
WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-776-5191 for assistance.
OPERATION
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you
are assembling parts, making adjustments, cleaning,
or when not in use. Removing battery pack will prevent
accidental starting that could cause serious personal
injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes and other possible
serious injuries.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:
Cutting wood, drywall, plastic

Detail sanding

Using accessories identified as compatible with this

multitool
WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended for use
with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.
LED LIGHT
The LED light, located on the front of the tool, illuminates
when the switch trigger is depressed. This provides extra
light for increased visibility.
WARNING:
Battery tools are always in operating condition. Release
the switch trigger and place the variable speed dial in the
OFF position when not in use or carrying at your side.
ON/OFF/VARIABLE SPEED
See Figure 1, page 9.
The tool is in the OFF position when the variable speed

dial is turned fully clockwise to "0" and the switch trigger
is released.
NOTE: You should feel the dial click into the detent when
the dial is turned to the OFF position.
The tool will not start if the dial is in the OFF position.

To turn the tool ON, pull the switch trigger and rotate the

variable speed dial counterclockwise.
Continue turning the dial counterclockwise to select

higher speeds.
Turn the dial clockwise to decrease speed.

To stop the tool, release the switch trigger. Turn the dial

fully clockwise to the OFF position.
NOTE: Running at low speeds under constant usage may
cause the tool to become overheated. If this occurs, cool
the tool by running it without a load and at full speed.
5 – English