USER CONTROLS
Note:
Password default value is "000000" (first time).
Always keep the password in your files. If the password is forgotten or lost, please contact your local autho-
rized service center.
Remote Setting
IR function: When this function is "Off", the projector cannot be operated by the remote control.
Remote code: 00~99, default code (common code): 00
HDBaseT Control
The projector will automatically detect the signal from HDBaseT transmitter supplied. Choose "HDBaseT" to
•
activate Direct Power mode.
When HDBaseT control is ON, 12v trigger output signal will always be ON, even if the
•
projector is on Standby mode.
PIP-PBP Module
•
Version: Show PIP-PBP module software version.
•
Reset: Reset the PIP-PBP module.
•
USB Upgrade: Upgrade the PIP-PBP module software.
•
HDMI EQ: Set PIP-PBP module HDMI port EQ value.
Information Hide
•
On: Choose "On" to hide the info message.
•
Off: Choose "Off" to show the "info" message.
Information
Display the projector information for model name, SNID, source, resolution, software version, aspect ratio, SSI
Hours, IP Address and Network Status on the screen.
Signal Power On & HDBaseT Standby
To access Signal Power On and HDBaseT Standby menu -- with projector on press the following buttons (in order):
Power > Up >Down> Menu.
Signal Power On
•
On: Choose "On" to enable Signal Power On.
•
Off: Choose "Off" to disable Signal Power On.
HDBaseT Standby
•
On: Choose "On" to enable HDBaseT Standby.
•
Off: Choose "Off" to disable HDBaseT Standby.
English 35