Download Print this page

Maintenance - Genelec 1238A Operating Manual

Smart active monitors
Hide thumbs Also See for 1238A:

Advertisement

HEAVY WOODEN WALL
ABSORBING
MATERIAL
AMPLIFIER
REMOVED
FROM ENCLOSURE
VIBRATION
ISOLATORS
f ~ 2-8 Hz
Figure 11. Flush mounting the monitorin
a wall constructed of wood
Button press
Short press
Long press
Special mode: one short
press
Short press advances
Short press advances
Short press advances
Special selection: long press
Special mode: no press for
60 seconds
Table 2. Power button actions to activate testing modes

Maintenance

No user serviceable parts are to be found
within the monitor enclosure or the RAM-L
amplifier unit. Any maintenance or repair of
the monitor should only be undertaken by
qualified service personnel.
CONCRETE WALL
SAND
BAGS
AMPLIFIER
REMOVED
FROM ENCLOSURE
VIBRATION
ISOLATORS
f ~ 2-8 Hz
Figure 12. Flush mounting the monitor in
a wall constructed of concrete
Function
Power on, power off
Enter special mode, exit
special mode
Mode 1: AES/EBU channel
A selected, room-related
calibration in use
Mode 2: AES/EBU channel
B selected, room-related
calibration in use
Mode 3: AES/EBU channel A
selected, factory calibration
in use
Mode 4: AES/EBU channel B
selected, factory calibration
in use
Once a special mode 1-4 has
been selected, a long press
selects the special mode
RAM-L exits the special
mode and turns off
Genelec 1237A and 1238A are supplied with
a two year guarantee against manufacturing
faults or defects that might alter the perfor-
mance of the monitors. Refer to supplier for
full sales and guarantee terms.
Notes
Press longer than 5 seconds
Power button light blinks
once every few seconds
Power button light blinks
twice every few seconds
Power button light blinks
three times every few sec-
onds
Power button blinks four
times every few seconds
Press longer than 5 seconds;
the RAM-L selects the spe-
cial mode and starts playing.
To exit the special mode turn
off the amplifier.
Automatically happens if user
does not press the power
button
Guarantee
MULTI-LAYERED WALL
(WOOD, CONCRETE,
BRICKS)
AMPLIFIER
REMOVED
FROM
ENCLOSURE
CONCRETE
STRUCTURE
VIBRATION
ISOLATORS
f ~ 2-8 Hz
Figure 13. Flush mounting the monitor
in a wall constructed of a combination
of materials.
SPEAKER
RUBBER GASKET
(5-10 mm / ¼-½")
FACING PANEL
FIXED TO THE WALL
(50-100 mm / 2-4")
WALL
Figure 14. Covering the gap between
the wall and the monitor cabinet.
Accessories
A wide selection of accessories is available
for Genelec monitors. Consult the Accesso-
ries Catalogue on www.genelec.com or your
local distributor/dealer for up-to-date informa-
tion.
Compliance to FCC Rules
This device complies with part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
1.
This device may not cause harmful
interference
2.
This device must accept any interfer-
ence received, including interference
that may cause undesired operation.
Note: This equipment has been tested and
found to comply with the limits for a Class
B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to pro-

Advertisement

loading

This manual is also suitable for:

1237a1238apm1237apm