Sony FDRX3000/W Manual page 111

Note on moisture condensation
Moisture may condense when you bring the camera from a cold place into a warm place (or vice
versa) or when you use the camera in a humid place as shown below.
When you bring the camera from a ski slope into a warm place.
When you bring the camera from an air conditioned car or room into a hot place outside.
When you use the camera after a squall or a shower.
When you use the camera in a hot and humid place.
How to avoid moisture condensation
When you bring the camera from a cold place into a warm place, put the camera in a plastic bag and
seal it tightly. Remove the bag when the air temperature inside the plastic bag has reached the
ambient temperature (after about 1 hour).
[114] Information
Notes on optional accessories
Genuine Sony accessories may not be available in some countries/regions.
[115] Information
On using the camera in close proximity to vibrating
motors and engines (FDR-X3000/HDR-AS300)
Distortion in image quality or out-of-focus may occur when used in close proximity to vibrating
motors and engines.
In this case, Motor Vibration Absorber for X3000/AS300 "AKA-MVA" (accessory sold separately,
available in autumn 2016) helps minimize distortion or out-of-focus.
[116] Information
Note on disposal/transfer of the memory card
Even if you delete data in the memory card or format the memory card on the camera or a computer,
you may not delete data from the memory card completely. When you give the memory card to
somebody, it is recommended that you delete data completely using data deletion software on a
computer. Also, when you dispose of the memory card, it is recommended that you destroy the actual
Precautions
Precautions
Precautions