Table of Contents
Advertisement
1
Open the battery compartment.
2
Insert 2 AAA batteries with correct polarity
(+/-) as indicated.
3
Close the battery compartment.
Note
•
If you are not going to use the remote control for a long
time, remove the batteries.
•
Do not use old and new or different types of batteries
in combination.
•
Batteries contain chemical substances, so they should be
disposed of properly.
Find the correct viewing channel
1
Press
to turn on this product.
2
Turn on the TV and switch to the correct
video-in channel (refer to the TV user manual
on how to select the correct channel).
Use the Home menu
Settings
1
Press
.
•
To start disc play, select
•
To access the setup menus, select
[Settings].
Navigate the menu
1
When a menu is displayed, press the buttons
on the remote control to navigate.
Button
OK
[Play Disc].
Action
Move up or down.
Move left or right.
Confirm a selection.
Enter numbers.
Select menu display language
Note
•
If this product is connected to a HDMI CEC compliant
TV, skip this setting. It switches automatically to the
same OSD menu language as per your TV setting (if the
language set on TV is supported by this product).
1
In the Home menu, select [Settings] and press
OK.
2
Select [Preference Setup], then press .
3
Select [Menu Language], then press .
Menu Language
Video Setup
Parental Control
Screen Saver
Audio Setup
Change Password
Preference Setup
Display Panel
Auto Standby
EasyLink Setup
VCD PBC
Advanced Setup
•
The language options may vary from
different regions.
4
Press
to select a language, then press OK.
Setup network
To enjoy software updates of this product and BD-
Live bonus contents for certain Blu-ray discs, set up
the network connection.
Note
•
Ensure that the network cable is properly connected and
the router is switched on.
1
Connect this product to the broadband
modem or router.
2
In the Home menu, select [Settings] and press
OK.
3
Select [Advanced Setup], then press .
4
Select [Network], then press OK.
5
Select [Next] in the menu, then press OK.
»
This product starts to detect if there is a
connection to the network.
»
If the connection test fails, select
and press OK to re-connect again to the
network.
[Retry]
EN
11
Advertisement
Table of Contents
