Engine Maintenance; Servicing The Air Cleaner; Changing The Engine Oil - Toro MM Series Operator's Manual

Mortar mixer
Hide thumbs Also See for MM Series:
Table of Contents

Advertisement

Engine Maintenance

Servicing the Air Cleaner

Service Interval: Before each use or daily—Inspect the
air-cleaner elements.
Every 50 hours—Clean the air-cleaner elements. Clean
them more frequently in dusty operating conditions.
Every 300 hours/Yearly (whichever comes
first)—Replace the paper air-cleaner element. Replace
it more frequently in dusty operating conditions.
Important: Do not operate the engine without the
air-filter assembly; extreme engine damage will occur.
1. Stop the engine and wait for all moving parts to stop.
2. Disconnect the wire from the spark plug; refer to
Disconnecting the Spark-plug Wire (page 28).
3. Remove the nut that secures the cover (Figure 50).
1
2
3
4
5
6
Figure 50
1. Cover nut
2. Cover
3. Wing nut
G020216
4. Foam element
5. Paper element
6. Base
4. Remove the cover.
Note: Be careful to prevent dirt and debris from
falling into the base.
5. Remove the foam and paper elements from the base
(Figure 50).
6. Remove the foam element from the paper element
(Figure 50).
7. Inspect the foam and paper elements, and replace them
if they are damaged or excessively dirty.
8. If the paper element is excessively dirty, replace it.
Note: Never try to brush dirt off the paper element;
brushing forces the dirt into the fibers.
9. Clean the foam element in warm, soapy water or in a
nonflammable solvent.
Note: Do not use fuel to clean the foam element
because it could create a risk of fire or explosion.
10. Rinse and dry the foam element thoroughly.
11. Dip the foam element in clean engine oil, then squeeze
out the excess oil.
Note: Excess oil in the foam element restricts the air
flow through the element and may reach the paper
filter and clog it.
12. Wipe dirt from the base and the cover with a moist rag.
Note: Be careful to prevent dirt and debris from
entering the air duct leading to the carburetor.
13. Install the air-cleaner elements and ensure that they are
properly positioned.
14. Securely install the cover with the nut.

Changing the Engine Oil

Service Interval: After the first 25 hours
Every 100 hours
Toro Premium Engine Oil is available from your Authorized
Toro Dealer.
Important: Use 4-cycle engine oil that meets or exceeds
the requirements for API service category SJ, SL, SM,
or higher .
Model(s)
68012, 68014
68016, 68017, 68020, 68021,
68024
Important: If the oil level in the crankcase is too low
or too high and you run the engine, you may damage
the engine. This type of damage is not covered by the
warranty.
30
Crankcase capacity
0.58 L (0.61 US qt)
1.1 L (1.2 US qt)

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mm-658h-p6801368014680166801768020 ... Show all

Table of Contents