Use Of Wired Remote Controller Installation / Service Mode - Samsung AE090JNYDGH User Manual

Use of wired remote controller installation / service mode

Use of installation/service mode
1 If you want to use the installation/service mode for your wired remote controller, press the Set
and ESC buttons at the same time for more than 3 seconds.
• You will enter the installation/service settings, and the 'main menu' will be displayed.
2 Refer to the list of installation / service setting mode for your wired remote controller on the next
page, and select the desired menu.
• Using the [ ]/[ ] buttons, select a main menu number and press the [ ] button to enter the sub-
menu setting screen.
• Using the [ ]/[ ] buttons, select a sub-menu number and press the [ ] button to enter data
setting screen.
• When you enter the setting stage, the current setting value will be displayed.
• Refer to the chart for data settings.
• Using the [ ]/[ ] buttons, change the setting value. Press the [ ] button to move to the next
setting value.
• Press the Set button to save the setting value and exit to the sub-menu setting screen.
• Press the ESC button to exit to normal mode.
NOTE
• When setting the data, you can move SEG range with [ ]/[ ] buttons.
• While configuring the setting, press the ESC button to exit to the sub-menu setting screen
without saving your changes.
• When you don't enter any buttons for more than 3 minutes, you will be back to normal mode.
SEG Used
Sub-menu
Main menu
1 2 3 4
33 33
English English