DeWalt DWE8200PL Manual page 12

ENG L I S H
CAUTION: Wheel or brush must not
touch guard when mounted or while
in use. Undetectable damage could
occur to the accessory, causing wires to
fragment from accessory wheel or cup.
1. Thread the wheel on the spindle by hand.
2. Depress spindle lock button and use a wrench
on the hub of the wire wheel or brush to tighten
the wheel.
3. To remove the wheel, reverse the above
procedure.
NOTICE: Failure to properly seat the wheel hub
before turning the tool on may result in damage to
tool or wheel.
The recommended diameter of Wire Brushes
DWE8 00T
DWE8210PL) .
Fitting and Removing a
Backing pad/Sanding sheet
1. Place the tool on a table or flat surface, with the
guard facing up.
2. Remove the backing flange (d).
3. Place the rubber backing pad correctly onto the
spindle (b).
4. Place the sanding sheet on the rubber backing
pad.
5. Screw the threaded clamp nut (e) onto the
spindle. The ring on the threaded clamp nut
must face towards the rubber backing pad.
6. Press the spindle lock button (a) and rotate the
spindle (b) until it locks in position.
7. Tighten the threaded clamp nut (e) with the hex
key provided or a two pin spanner.
8. Release the spindle lock.
9. To remove the rubber backing pad, loosen
the threaded clamp nut (e) with the hex key
provided or a two pin spanner.
The recommended diameter of backing pad/
sanding sheet for the tool is 100mm(DWE8 00S,
DWE8 00T
DWE8210PL) .
Fitting a Wire Cup Brush
Screw the wire cup brush directly onto the spindle
without the use of the spacer and threaded flange
10
00S,
) or 125mm(DWE8 10S,
) or 125mm(DWE8210S,
100mm Grinding Wheels
Type 27 guard
backing flange
Type 27 depressed
center wheel
clamp nut
Wire Wheels
Type 27 guard
75mm wire cup bruch
100mm Cutting Wheels
Type 1 guard
backing flange
abrasive cutting wheel
clamp nut
Type 27 guard
100mm wire cup bruch
Type 1 guard
backing flange
diamond cutting wheel
clamp nut