Ryobi ONE+ OLT1833-0 Original Instructions Manual page 4

■
Before use and after any impact, check that
there are no damaged parts. A defective
switch or any part that is damaged or worn
should be properly repaired or replaced by
an authorised service centre.
■
Make sure the cutting attachment is
properly installed and securely fastened.
■
Never operate the product unless all
guards, deflectors,
properly and securely attached.
■
Consider the environment in which you are
working. Keep the working area free from
wires, sticks, stones, and debris which if
struck by the cutter can become thrown
objects.
BATTERY TOOL USE AND CARE
■
Recharge only with the charger specified
by the manufacturer. A charger that is
suitable for one type of battery pack may
create a risk of fire when used with another
battery pack.
■
Use power tools only with specifically
designated battery packs. Use of any other
battery packs may create a risk of injury
and fire.
■
When battery pack is not in use, keep it
away from other metal objects, like paper
clips, coins, keys, nails, screws, or other
small metal objects that can make a
connection from one terminal to another.
Shorting the battery terminals together
may cause burns or a fire.
■
Under abusive conditions, liquid may be
ejected from the battery; avoid contact.
If contact accidentally occurs, flush with
water. If liquid contacts eyes, additionally
seek medical help. Liquid ejected from the
battery may cause irritation or burns.
LAWN TRIMMER SAFETY WARNINGS
■
Never allow children, persons with reduced
physical, sensory, or mental capabilities,
or lack of experience and knowledge or
people unfamiliar with these instructions to
use the product.
■
Use the product in daylight or good with
artificial light.
2 | English
and handles are
■
Avoid using on wet grass.
■
Keep proper footing and balance at all
times and be sure of proper footing on
slopes.
■
Do not walk backwards when using the
product.
■
Walk, never run.
■
Keep the head attachment below waist
level.
■
Never use the product with damaged
guards or without guards in place.
■
Do not fit a metal replacement line.
■
Keep hands and feet away from the
cutting means at all times especially when
switching on the motor.
■
Beware, the cutting elements continue to
rotate after the motor is switched off.
■
Beware of objects thrown by the cutting
means. Clear debris like small stones,
gravel, and other foreign objects from the
work area before starting operation. Wires
or string may become entangled with the
cutting means.
■
Switch off and remove the battery pack
before:
●
servicing
●
leaving the product unattended
●
cleaning your product
●
changing accessories
●
checking for any damage after hitting an
object
●
checking for any damage if the product
starts to vibrate abnormally
●
performing maintenance
■
Wear full eye and hearing protection while
using the product. If working in an area
where there is a risk of falling objects, head
protection must be worn.
■
Hearing protection
operator's ability to hear warning sounds.
Pay particular attention to potential hazards
around and inside the working area.
■
Wear long trousers, boots, and gloves.
Do not wear loose fitting clothing, short
trousers, jewellery of any kind, or use with
bare feet.
may restrict the