Table of Contents
Advertisement
Clean the filter on the back of the
6.
appliance:
Remove the hose from the rear of
the appliance.
Take out the filter with pliers and
clean it.
Connect the hose and check for
7.
leaks.
Air filter blocked
Turn the programme selector to Ú
1.
Stop. Pull out the mains plug.
Open and remove the service flap.
2.
Take out the air filter.
3.
Rinse fluff off the air filter using
4.
a brush under running water.
Re-insert the air filter.
5.
Re-insert and close the service flap.
6.
Faults and what to do about them
3
Faults and what to do
about them
E mergency release, e.g. if a
F a u l t s a n d w h a t t o d o a b o u t t h e m
power failure occurs
The programme continues running
when the power supply is restored. If
the washing is still to be removed, the
door can be opened as described
below:
:
Warning
Risk of scalding!
When washing at high temperatures,
you may be scalded if you touch hot
washing water or the laundry.
If required, leave to cool down.
:
Warning
Risk of injury!
If you reach into the rotating drum, you
may injure your hands.
Do not reach into the rotating drum.
Wait until the drum stops rotating.
Caution!
Water damage
Leaking water may cause damage.
Do not open the door if you can still see
water through the glass.
Turn the programme selector to Ú
1.
Stop. Pull out the mains plug.
Drain the detergent solution.
2.
Pull down emergency release with
3.
a tool and release.
Door can then be opened.
en
31
Advertisement
Table of Contents
