Pelgrim GVW840L Operating Instructions Manual page 23

Problem
Spots or films on the dishes.
The dishes have a sticky
white/blue film.
Spots left after washing.
Detergent residue in the
detergent compartment after
dishwashing.
Rattling sound when
dishwashing.
Possible causes
The water softener is
leaking salt.
Incorrect water softener
setting.
Incorrect rinse aid dosage
setting.
Salt compartment empty.
3-in-1/ All-in-one detergent
is used and the setting TAB
(3-in-1/ All-in-one detergent)
is activated.
Too high temperature and/or
too much detergent can
cause etching on crystal.
Unfortunately, this cannot
be repaired, only prevented.
Rinse aid dosage setting too
high.
Lipstick and tea can be
difficult to wash off.
The detergent compartment
was damp when adding
detergent.
The dishes are not correctly
placed or the spray arms are
not rotating.
Action
Check that the salt
compartment lid is properly
tightened. Otherwise call the
service department.
See the section Settings.
See the section Settings.
Top up with salt. See the
section Before washing for
the first time.
Inactivate the setting TAB
(3-in-1/ All-in-one detergent)
and top up salt and rinse
aid.
Wash crystal at a low
temperature and with a
conservative amount of
detergent. Contact the
detergent manufacturer.
Reduce the amount. See the
sections Before washing for
the first time and Settings. If
you have very soft water,
you may want to dilute the
rinse aid 50:50 with water.
Use a detergent with a
bleaching agent.
The detergent compartment
must be dry when adding
detergent.
Check that the dishes are
placed securely. Spin the
spray arms to make sure
they can rotate.
23