Page 1
QG-PRO-PM-VCA-B Joining the Pipe to the Ceiling Adapter QG-PRO-PM-VCA-W IMPORTANT! Do not loosen screws all the way when making adjustments, this may disconnect the parts and may cause injury or property damage. Ceiling (D) x 2 ±45° (E) x 2 1.5"...
Page 2
Before starting installation, please check that all parts shown in this checklist are included. If any parts are missing or damaged, contact your local distributor or support@qualgear.com for replacement parts and do not start assembly and installation WARNING until you receive all the parts.
Page 3
Mounting to a Vaulted Wooden Joist or Wooden Stud Ceiling For concrete ceiling mounting, NOTE follow step 1b. Stud Finder Using a power drill and a 5/32" wood drill bit, drill holes of 5/32" (4mm) diameter, and 2.5" (65mm) depth at the marked locations. Using an edge-to-edge stud finder, find the Using a straight edge, mark the centerline Mounting to a Vaulted Concrete Ceiling...
Page 4
Installing the Vaulted Ceiling Adapter to the Ceiling WOODEN JOIST CEILING Align the mounting holes on the vaulted ceiling adapter with the drilled holes on the ceiling, insert screws (A) into the mounting holes and tighten with a socket wrench. Using a power drill and a 3/8"...