Electro-Voice ELX200 Installation Manual page 29

ELX200 Powered Loudspeakers
EXIT Menu
The Exit menu is used to return to the home screen.
Notice!
The display returns to the home screen after two minutes of inactivity.
MODE Menu
The Mode menu is used to configure the type of sound the subwoofer delivers.
–
–
–
LOW PASS Menu
The LOW PASS menu is used to select low pass frequency for proper summation with a full-
range loudspeaker.
The low passes are 24 dB/octave Linkwitz/Riley slopes. The 80 Hz, 100 Hz, 120 Hz, and 150 Hz
selections are generic low pass settings for use with other full-range loudspeaker systems. The
ELX200-10P, ELX200-12P, ELX200-15P, ZXA1, EKX-12P, EKX-15P, ELX112P, ELX115P,
ZLX-12P , and ZLX-15P settings are specifically optimized for full-range loudspeakers for best
summation.
The default is 100 Hz.
LED Menu
The LED menu shows power on and indicates limit. Available options for this selection are:
ON, OFF or LIMIT.
–
–
–
The default is ON.
LCD DIM Menu
The LCD Dim menu is used to dim the display when the display is idle for two minutes.
Available options for this selection are: ON or OFF.
The default is ON.
BRIGHT Menu
The Bright menu is used to determine the brightness of the LCD.
The range is 1 to 10.
The default is five.
CONTRAST Menu
The Contrast menu is used to increase or decrease the visibility of the LCD screen.
The range is 1 to 10.
The default is five.
STORE Menu
The Store menu allows you create up to five customized user settings. Available options for
this selection are: EXIT, 1, 2, 3, 4, and 5.
Electro-Voice
MUSIC – is used for recorded music playback and electronic dance music applications.
(Default)
LIVE – is used for live sound applications.
CLUB – is used for recorded electronic music playback.
ON – turns the LED on when the power to the loudspeaker is ON. (Default)
OFF – turns the LED off.
LIMIT – turns the LED off under normal operation. The LED brief blinking indicates the
limiter is activating. Short-term blinking is not critical because the integrated limiter
keeps distortion under control. Constant lighting of the LED indicates the sound is
negatively affected. If the LED is constantly lit, check the rear LCD for more information.
Reducing the output volume is strongly recommended.
Installation manual
Amplifier DSP | en 29
2019-04 | 03 | F.01U.326.891