Table of Contents
Advertisement
4
Pull the connector latch plate d down, push
the inlet hose onto the adapter, and release
the connector latch plate. Make sure the
adapter locks into place.
NOTE
• After connecting the water inlet hose to the
water tap, turn on the water tap to flush out
foreign substances (dirt, sand, sawdust, and
etc.) in the water lines. Let the water drain into
a bucket, and check the water temperature.
Connecting the Hose to the
Appliance
Screw the water inlet hose to the water inlet valve
on the back of the appliance.
• Do not connect the hose to the hot water
supply for models with one water inlet. Connect
to the cold water supply only.
NOTE
• After completing connection, if water leaks from
the hose, repeat the same steps. Use the most
conventional type of tap for the water supply. In
case that the tap is square or too big, remove
the guide plate before inserting the tap into the
adaptor.
Installing the Drain Hose
Before connecting the drain hose, check your drain
hose model and choose the correct instruction.
Installing the Drain Hose without
the Elbow Bracket
1
Push the elbow hose toward the body of the
appliance.
2
To change the direction of the hose, pull out
the elbow hose and change the direction.
Repeat Step 1.
Positioning the Drain Hose
• The length of the drain hose should not exceed
300 cm. Do not place the drain hose more than
6 cm above the threshold.
11
Advertisement
Table of Contents
