Atag CU12511RM Instructions For Use Manual page 50

USE
EN 8
Switch on boost setting
• Press and hold the '+' key for at least 1 second.
The boost setting is switched on for 10 minutes. The speed level 4
indicator will flash during this period. The original extraction setting
will be reactivated after this period.
• Press and release the '-' key to switch off the boost setting.
Note!
If the boost setting has been selected, the timer function cannot be activated.
Switching on the timer
• Press the timer key.
The timer indicator will start to blink.
The cooker hood will switch off automatically after 10 minutes.
• Switch off the timer function by pressing a random key (except the
one for lighting).
The cooker hood can be used in extraction mode or recirculation mode. The
air extraction capacity is adapted to the selected mode. The hood will start
up in the default extraction mode. Is has to be reset for recirculation mode.
With an RMS kit (recirculation modification set) the air will first be cleaned by
the grease filters and then odours will be filtered by the charcoal filter. The
cleaned air is recirculated back into the kitchen.
Switching on recirculation mode
• When the light and fan are off, simultaneously hold the timer key
and the light key until the filter indicator flashes 3 times.
The carbon filter indicator is activated.
Switching off recirculation mode
• When the light and fan are off, simultaneously hold the timer key
and the light key until the filter indicator lights up for 3 seconds and
then turns off.