Sirius Satellite Radio GS1SI2TK1 User Manual page 53

Step 8: Permanently install the FEA
Note: If you are mounting the FEA in the vehicle's headliner, skip this step.
When you are satisfi ed with the FEA's mounting location, remove the suction cup mounts
and peel the backing off the bead and arrow adhesive mounts. Clean the area where the
FEA will be attached with the alcohol swab. Permanently adhere the FEA in the same
position on the glass (or A-pillar), making certain the wire is taut and is as straight as
possible (see Figure 30). If necessary, use the cable guides to hold the cable.
REMOVE REMOVE REMOVE
ADHESIVE BACKING BOTH SUCTION CUPS ADHESIVE BACKING
FROM ARROW FROM BEAD
THIS THINNER PORTION OF THE FEA USE THE CABLE GUIDES TO HOLD THE CABLE
SHOULD BE TAUT WHEN THE FEA IN POSITION UNTIL IT REACHES
IS PERMANENTLY ADHERED THE INNER TRIM OR MOULDING
Figure 30
[ ]
53
Installation