Table of Contents
Advertisement
assword
eep this number in a safe place.
.
onfirm the new password by re-entering the new password.
.
You have successfully assigned a new password to the projector. emember to enter the new password ne t time
the projector is started.
.
To leave the S menu, press ME U E
isabling the ass or
To disable password protection, go back to the SYSTEM SETUP:
menu after opening the S menu system. Select
displayed. nter the current password.
•
f the password is correct, the S menu returns to the Sec rit Settings page with
Po er on loc . You will not have to enter the password ne t time you turn on the projector.
•
f the password is incorrect, the password error message is displayed lasting for three seconds, and the message
PUT P SS
another password.
hough the password function is disabled, you need to keep the old password in hand should you ever need to re-activate the
password function by entering the old password.
S itching in
The projector can be connected to multiple devices at the same time. owever, it can only display one full screen at a
time.
e sure the
ic
want the projector to automatically search for the signals.
You can also manually cycle through the available input signals.
.
Press S URCE on the projector or remote control. A source selection bar
is displayed.
.
Press
E TER.
nce detected, the selected source information will be displayed on the
screen for seconds. f there is multiple equipment connected to the
projector, repeat steps - to search for another signal.
•
he brightness level of the projected image will change accordingly when you
switch between different input signals. ata graphic " C" presentations using
mostly static images are generally brighter than "Video" using mostly moving
images movies .
•
he input signal type effects the options available for the Setting. See
picture mode" on page
•
he native display resolution of this projector is in a
E
1 -S
aspect ratio. or best display picture results, you should select and
use an input signal which outputs at this resolution. Any other resolutions will be
scaled by the projector depending upon the aspect ratio setting, which may
cause some image distortion or loss of picture clarity. See
ratio" on page
Changing Color S ace
n the unlikely event that you connect the projector to a
picture displays wrong colors, please change the color space to YU .
.
Press ME U E
.
Press
to highlight Color S ace Con ersion and press
his function is only available when the H
EN-
nction
R
is displayed for your retry. You can press ME U E
t signal
to Search function in the S URCE menu is n which is the default of this projector if you
until your desired signal is selected and press M
for details.
for details.
T and then press
I input port is in use.
T.
ance > Sec rit Settings
by pressing
. The message
E
"Selecting a
E
1 -S
1 1
"Selecting the aspect
player via the projector s
until the S URCE menu is highlighted.
to select a suitable color space.
Po er on loc
PUT P SS
R
shown in the row of
T to cancel the change or try
M input and the projected
is
Advertisement
Table of Contents
