Message List - Roland RP302 Owner's Manual

° Message List
Indication Meaning
The music file you attempted to save is read-only. It cannot be
E.01
saved.
An error occurred while writing. It may be that the protect tab of
E.02
the external media is in the "Protect (write prohibit)" position, or
that the external media has not been formatted.
No USB flash drive connected. Connect a USB flash drive and try
E.10
the operation again.
There is insufficient free space at the save destination. Either
E.11
connect a different USB flash drive, or delete unwanted data
(song data) and try the operation again.
An error occurred while reading. The USB flash drive may be
E.14
damaged. Connect a different USB flash drive and try the operation
again. You may also format the USB flash drive (p. 7).
The file could not be read. The data format is not compatible with
E.15
the unit.
The data could not be read fast enough during song playback.
E.16
After waiting several seconds, you may be able to play back the
song by pressing the [ s ] button once again.
This audio format is not supported. Please use WAV format, 44.1
E.18
kHz, 16-bit linear audio files.
E.30
The unit's internal memory is full.
The unit cannot deal with the excessive MIDI data sent from the
E.40
external USB MIDI.
Reduce the amount of MIDI data sent to the unit.
There may be a problem with the system.
Repeat the procedure from the beginning. If it is not solved after
E.51
you have tried a number of times, contact the Roland service
center.
The USB flash drive connector was subjected to excessive current.
E.65
Make sure that there is no problem with the external media, then
turn the power off, then on again.
- - -
The Panel Lock function is on (p. 9).
When playing back a song, this is shown if the song starts with a
PU
pickup.
Blinking When the Auto Off function is activated, the remaining time blinks
number before the power turns off.
15