Table of Contents
Advertisement
Before Operation
AUDIO
Each DVD disc has a variety of audio output options.
Set the player's AUDIO options according to the type of
audio system you use.
AUDIO
Dolby Digital
DTS
MPEG
Sample Freq.
5.1 Speaker Setup
DRC
Vocal
Dolby Digital / DTS / MPEG
Bitstream: Select "Bitstream" if you connect the DVD
Player's DIGITAL OUT jack to an amplifier or other
equipment with a Dolby Digital, DTS or MPEG decoder.
PCM : Select when connected to a two-channel digital
stereo amplifier. DVDs encoded in Dolby Digital or MPEG
will be automatically downmixed to two-channel PCM audio.
Sample Freq. (Frequency)
If your receiver or amplifier is NOT capable of handling
96 kHz signals, select 48 kHz. When this choice is
made, this unit automatically converts any 96 kHz
signals to 48 kHz so your system can decode them.
If your receiver or amplifier is capable of handling 96
kHz signals, select 96 kHz. When this choice is made,
this unit passes each type of signal through without any
further processing.
Check the documentation for your amplifier to verify its
capabilities.
Bitstream
Bitstream
PCM
48 kHz
Select
On
On
Move
Select
DVD
DVD
5.1 Speaker Setup
DVD
Select speaker settings, including volume balance and
distance, or test the speaker settings.
Speaker settings are only active on the Analog Multi-
Channel Output.
Speaker Setup
Make the following settings for the built-in 5.1 channel
surround decoder.
AUDIO
Speaker
Front L
Size
Small
dB
Volume
0
Distance
0
m
Test
Off
Select
Move
1. Press SETUP. The setup menu appears.
2. Use
/
to select the AUDIO option then press
to move to the second level.
3. Use
/
to select the Speaker Setup option then
press
to move to the third level. "Select" is high-
lighted.
4. Press SELECT/ENTER and 5.1 Speaker Setup
menu appears.
5. Use
/
to select the desired speaker.
6. Adjust options using
7. Press SELECT/ENTER to confirm your selection.
Returns to the previous menu.
Speaker selection
Select a speaker that you want to adjust. [Front speaker
(Front L), Center Speaker (Center),Front speaker (Front
R), , Rear speaker (Rear R), Rear speaker (Rear L) or
Subwoofer (Woofer)]
Size
Press
/
to set a mode. (Large, Small or None)
• The size of the Front L/R speaker can be selected to
"Large" or "Small".
• The size of the Subwoofer can be selected to "Large"
or "None".
• Since the size of the Center and Rear L/R speaker
are fixed to "Small", you can not change settings.
• If you have connected the system to a speaker with low
frequency of 100Hz or below, select to "Large" the size
of the Front L/R speaker. The size of the Subwoofer is
selected to "None" automatically.
• If you have connected the system to a speaker
without low frequency of 100Hz or below, select to
"Small" the size of the Front L/R speaker. The size of
the Subwoofer is selected to "Large" automatically. But
if you haven't connected to subwoofer, always select to
"Large" the size of Front L/R Speaker.
Return
ENTER
/
/
/
buttons.
23
Advertisement
Table of Contents
