Asus PRIME B360-PLUS Manual page 13

System panel connector (20-5 pin F_PANEL)
This connector supports several chassis-mounted
functions.
• System power LED (4-pin +PWR_LED-)
This 4-pin connector is for the system power LED.
Connect the chassis power LED cable to this
connector. The system power LED lights up when
you turn on the system power, and blinks when
the system is in sleep mode.
• Hard disk drive activity LED (2-pin +HDD_LED-)
This 2-pin connector is for the HDD Activity LED. Connect the HDD Activity
LED cable to this connector. The HDD LED lights up or flashes when data is
read from or written to the HDD.
• System warning speaker (4-pin SPEAKER)
This 4-pin connector is for the chassis-mounted system warning speaker.
The speaker allows you to hear system beeps and warnings.
• ATX power button/soft-off button (2-pin PWR_SW)
This connector is for the system power button. Pressing the power button
turns the system on or puts the system in sleep or soft-off mode depending
on the operating system settings. Pressing the power switch for more than
four seconds while the system is ON turns the system OFF.
• Reset button (2-pin RESET)
This 2-pin connector is for the chassis-mounted reset button for system
reboot without turning off the system power.
USB 3.1 Gen 1 (up to 5Gbps) connector (20-1 pin U31G1_12)
Connect a USB 3.1 Gen 1 module to this connector for additional USB 3.1
Gen 1 front or rear panel ports. This connector complies with USB 3.1 Gen 1
specifications and provides faster data transfer speeds of up to 5 Gbps, faster
charging time for USB-chargeable devices, optimized power efficiency, and
backward compatibility with USB 2.0.
USB 2.0 connector (10-1 pin USB1114)
Connect a USB module cable to this connector, then install the module
to a slot opening at the back of the system chassis. This USB connector
complies with USB 2.0 specifications and supports up to 480Mbps
connection speed.
Serial port connector (10-1 pin COM)
This connector is for a serial (COM) port. Connect the serial port module
cable to this connector, then install the module to a slot opening at the back
of the system chassis.
Chapter 1: Product introduction
PANEL
+PWR_LED- SPEAKER
PWR_SW
PIN 1
+HDD_LED- RESET
+PWR_LED-
* Requires an ATX power supply
1-4