Asus PRIME B360-PLUS Manual page 11

ATX power connectors (24-pin EATXPWR, 8-pin EATX12V)
Correctly orient the ATX power supply plugs into these connectors and push down
firmly until the connectors completely fit.
CPU and chassis fan connectors (4-pin CPU_FAN, 4-pin CHA_FAN1~2)
Connect the fan cables to the fan connectors on the motherboard, ensuring that the
black wire of each cable matches the ground pin of the connector.
Intel LGA1151 CPU socket
®
Install Intel
designed for 8th Generation Intel
processors.
DDR4 DIMM slots
Install 2 GB, 4 GB, 8 GB, and 16 GB unbuffered non-ECC DDR4 DIMMs into these
DIMM sockets.
Chapter 1: Product introduction
• For a fully configured system, we recommend that you use a power supply
unit (PSU) that complies with ATX 12 V Specification 2.0 (or later version)
and provides a minimum power of 350 W. This PSU type has 24-pin and
8-pin power plugs.
• DO NOT forget to connect the 8-pin EATX +12V power plug. Otherwise,
the system will not boot up.
• We recommend that you use a PSU with higher power output when
configuring a system with more power-consuming devices or when you
intend to install additional devices. The system may become unstable or
may not boot up if the power is inadequate.
• If you are uncertain about the minimum power supply requirement for your
system, refer to the Recommended Power Supply Wattage Calculator at
http://support.asus.com.cn/PowerSupply.aspx?SLanguage=en for details.
Do not forget to connect the fan cables to the fan connectors. Insufficient air
flow inside the system may damage the motherboard components. These are
not jumpers! Do not place jumper caps on the fan connectors! The CPU_FAN
connector supports a CPU fan of maximum 1A (12 W) fan power.
LGA1151 CPU into this surface mount LGA1151 socket, which is
®
For more details, refer to Central Processing Unit (CPU).
For more details, refer to System memory.
Core™ i7 / i5 / i3, Pentium
®
, and Celeron
® ®
1-2