Table of Contents
Advertisement
Gigabit Ethernet Switch User's Guide
Figure 6-41. GMRP Configuration menu
The Switch GMRP field allows you to either enable or disable GMRP on the Switch by toggling between the
two choices and then pressing APPLY to let the change take effect.
Once GMRP is enabled for the Switch, you then must enable specific ports by selecting Configure Port
GMRP Settings from the GMRP Configuration menu above. The GMRP Configuration screen appears:
Figure 6-42. GMRP Configuration screen
Use this screen to enable or disable GMRP on individual ports. Press APPLY to let your changes take effect.
Configure Trunk
Ports on the switch can be grouped together in a single logical port called a trunk. This is discussed in detail
in the Port Trunking section of the chapter of this manual entitled "Switch Management Concepts." To set up
a trunk group, choose Configure Trunk from the System Configuration menu. The following screen
appears:
55
Advertisement
Table of Contents
